RSS Facebook

RCMF

Welcome, Guest. Please login or register.
September 24, 2017, 18:48:51 PM

Login with username, password and session length

Articles

Author Topic: I have a problem that location makes obtaining parts for project very expensive  (Read 110 times)

0 Members and 1 Guest are viewing this topic.

Offline solentlife

  • Brit in baltic
  • Trade Count: (0)
  • RCMF Wing Commander
  • ****
  • Thank You
  • -Given: 0
  • -Receive: 0
  • Posts: 274
  • Liked: 15
  • Country: gb
  • Tally Ho Chaps !
If anyone can help me - I would greatly appreciate.

I am slowly putting together a Chris Golds large Lancaster ... and I am having terrible trouble getting hold of the moulded parts. I was offered by RCM&E plans division a set at about 30 + over 60 post ! Later when I had a UK friend try - they were not available.

I have tried to create them on my 3D printer but I am totally useless at it.

Is there anyone who could help me with this ? Basically to produce the STL / image files ?

The parts are :

Engine cowls
Cockpit canopy
Bomb aimers 'globe'
Front, mid-upper and rear gunners glazing.

I have the full plans of the model ....

Cheers
Nigel
450se V2, Syma S006, ME109, 3D Aerobatic-wood, Extra, Pitts, Concorde. Tu144 etc... 9X, 9XR, JR Propo 8ch, Radiolink 6ch .... If you don't crash - you ain't flying !
Old hand returned to RC

 

BloQcs design by Bloc
SMF 2.0.2 | SMF © 2011, Simple Machines
SMFAds for Free Forums
TinyPortal © 2005-2012
Page created in 0.17 seconds with 33 queries.