Betst glue to use steel to carbon fibre

RCMF

Welcome to RCMF

The Uk's Premier Model Flying Forum

Putting the Community back in to Radio Control


Welcome, Guest. Please login or register.
May 23, 2012, 11:40:00 AM

Login with username, password and session length

Members on-line
« previous next »
Pages: 1 [2]  All   Go Down

Author Topic: Betst glue to use steel to carbon fibre  (Read 599 times)

0 Members and 3 Guests are viewing this topic.
Yoyo
Posts: 6,428
Reply #40
Offline Yoyo wrote Betst glue to use steel to carbon fibre on November 11, 2011, 18:27:51 PM
Quote from: bobt on November 11, 2011, 12:43:29 PM
Who?

T9hobbysport - they advertise on here.

Mainly a glider shop, probably why you haven't noticed them. Good service whenever I've used them.

Logged
Oh, hang on - it isn't 'fly it like you borrowed it, land it like you stole it', is it!
So that's where I've been going wrong...
liftseeker
Posts: 747
Reply #41
Online liftseeker wrote Re: Betst glue to use steel to carbon fibre on November 11, 2011, 19:02:25 PM
No, I like T9Hobbysport - they've got some lovely gliders on their site - I lke the Moth. Its where I got my Topsky from.

The only problem I have (and I must say its getting worse) is that I HAVE to lock my credit card away before browse the site

Logged
Yoyo
Posts: 6,428
Reply #42
Offline Yoyo wrote Betst glue to use steel to carbon fibre on November 11, 2011, 19:44:15 PM
Quote from: liftseeker on November 11, 2011, 19:02:25 PM
No, I like T9Hobbysport - they've got some lovely gliders on their site - I lke the Moth. Its where I got my Topsky from.

The only problem I have (and I must say its getting worse) is that I HAVE to lock my credit card away before browse the site

If you want a general gadgets and bits site that you can browse for hours  without running up too huge a bill, try dealextreme . The best bit is that postage is factored into all the prices so you don't get a nasty $15 added on at the end!

Logged
Oh, hang on - it isn't 'fly it like you borrowed it, land it like you stole it', is it!
So that's where I've been going wrong...
« previous next »
Pages: 1 [2]  All   Go Up