Reality Craft transmitter problem

RCMF

Welcome to RCMF

The Uk's Premier Model Flying Forum

Putting the Community back in to Radio Control


Welcome, Guest. Please login or register.
May 23, 2012, 18:56:03 PM

Login with username, password and session length

Members on-line
« previous next »
Pages: [1]   Go Down

Author Topic: Reality Craft transmitter problem  (Read 177 times)

0 Members and 1 Guest are viewing this topic.
AlexC
Posts: 314
Offline AlexC wrote Reality Craft transmitter problem on January 31, 2012, 18:25:08 PM
My Grandson has managed to damage the USB connector of his Reality Craft transmitter pulling the wires from the PCB. There are three wires, red, blue and black. Does anyone have one of these transmitters that can tell me where on the PCB these wires used to be so that I can re-solder them.


Logged
Darwil
Posts: 889
Reply #1
Offline Darwil wrote Reality Craft transmitter problem on January 31, 2012, 18:47:12 PM

Logged
Don't think about it, get on with it!!
AlexC
Posts: 314
Reply #2
Offline AlexC wrote Re: Reality Craft transmitter problem on February 01, 2012, 12:36:12 PM
Quote from: Darwil on January 31, 2012, 18:47:12 PM
These people may be able to help
http://www.cmldistribution.co.uk/cml_category.php?catId=182&range=AIR


They were a great help sending me  a .JPG with the wire connections.

Thanks for the link.

Logged
The Doc
Posts: 4,846
Reply #3
Offline The Doc wrote Re: Reality Craft transmitter problem on February 01, 2012, 12:39:01 PM
Quote from: AlexC on February 01, 2012, 12:36:12 PM
They were a great help sending me  a .JPG with the wire connections.

Thanks for the link.

Would it be possible for you to post the jpeg?

I have done exactly the same thing!!

Not reality craft but the tranny looks identical

CM

Logged
Remember... you dont need to out run a bear, you need to out run your mate!
AlexC
Posts: 314
Reply #4
Offline AlexC wrote Re: Reality Craft transmitter problem on February 01, 2012, 18:17:35 PM
Hi,

I have attached the photo sent to me. I think a bit of glue on the cover is needed when re-assembling the USB case.

Alex.

Logged
« previous next »
Pages: [1]   Go Up